The LVC-5000 system is not powering up when POWER, PoE and GPO LEDs have been lit. How could I troubleshoot the system?
Solution
Please perform the following steps for troubleshooting purpose:
When there is no beep sound after the system powers up
Shut down the system and remove all power sources from it to open the top cover. Open the top cover to remove the on-board battery (BAT1) and set it aside for about 1 minute, reinstall the battery and the top cover, and then turn on the system again.
When there is a beep sound after the system powers up
Shut down the system and remove all power sources from it to open the top cover. Check if the memory module is installed properly or install another memory module. Reinstall the top cover and then turn on the system again.